HIKVISION DS-2XC6745G0-IZHS

Chapter 10 VCA Resource
VCA resource is a collecon of smart funcons supported by the device.
10.1 Set Open Plaorm
HEOP (Hikvision Embedded Open Plaorm) allows you to install the applicaon for the third-party
to develop and run its
funcon and service. For the device supporng HEOP, you can follow the
steps to import and run smart
applicaons.
Steps
1.
Go to VCA interface.
Note
Before installing the applicaon, make sure that the applicaon you want to install ts the
following condions.
●
Each applicaon has its own exclusive name.
●
The FLASH memory space that the
applicaon takes up is less than the available FLASH
memory space of the device.
●
The memory and
compung power of the applicaon is less than that available memory and
compung power of the device.
2.
Click Import Applicaon and browse your local path to select an applicaon package and
import.
3.
Click Import License and browse your local path to select a license
le and import.
4.
Oponal: Set applicaon.
Click
Enable or disable the applicaon.
Click Delete the applicaon.
Click Export log.
Click Browse a local path and import an applicaon
package to update the applicaon.
View details Select an applicaon and click on it to show
the details on the page.
10.2 General Sengs
Set the general parameters which are related to the smart applicaons.
Go to VCA → Set Applicaon → General Sengs to set the following parameters.
Network Camera User Manual
74