HIKVISION DS-2XC6745G0-IZHS

Note
●
For certain device models, you need to enable People Management on VCA page rst.
●
The funcon is only supported by certain device models.
10.5.1 Regional People Counng
It counts people in a predened area and detects people number changes and crowded situaon.
When the people number excepon or waing me excepon occurs, the device can trigger an
alarm.
Refer to
Set People Density to set people density detecon.
Refer to Set People Excepon Detecon to set people excepon detecon.
Refer to Waing Time Excepon Detecon to set waing me excepon detecon.
Set People Density
This funcon detects the level of people density in the set rule region.
Before You Start
●
Go to VCA → Select Applicaon , select People Management and click Next to enable the
funcon.
●
For the device supporng HEOP, go to VCA to import and enable People Management.
Steps
1.
Go to VCA → Set Applicaon → People Management → Regional People Counng → Rule .
2.
Click Add to add a rule and set its name.
3.
Set a rule.
People Number OSD
It displays the
real-me people number in the live view window. You can drag the mouse to
adjust the OSD window locaon.
Note
People density detecon (people density alarm) does not support Alarm Times Per Excepon,
Alarm Interval and First Alarm Delay sengs.
4.
Click to draw a region in the live view window, le click the end-points in the live view
window to dene the boundary of the set rule region, and right click to nish drawing.
Note
●
Up to 8 regions can be set at the same me.
●
Try not to overlap the regions.
5.
Check People Density Alarm to enable the funcon.
Network Camera User Manual
90