HIKVISION DS-2XC6745G0-IZHS

Steps
1.
Go to VCA → Set Applicaon → People Counng → Rule .
2.
Check Enable to enable the funcon.
3.
Click Add to add a detecon area.
4.
Click
to draw the polygon detecon area (count area). Le-click end-points in the live view
window, and right-click to
nish the drawing.
5.
Click to draw the detecon line. The arrow shows entering direcon, you can click to
change the direcon.
Note
In order to improve the counng accuracy, please draw the detecon area according to the
following rules.
●
The detecon area needs to cover the people entering and exing access.
●
The
detecon line must be completely contained within the red detecon area and
perpendicular to the path of the person passing through.
6.
Oponal: Adjust the detecon area and detecon line.
Click Clear the selected detecon area or line.
Click Clear all detecon areas and lines.
7.
Oponal: Repeat the above steps to draw up to 3 detecon areas and corresponding detecon
lines.
8.
Set people counng parameters.
OSD Overlay Content
Select the counng data type to be displayed in the live view image from the drop-down list,
and adjust the display
posion of people counng data in the live view image.
Note
OSD overlay only counts the number of the person on the current day. The data will be
cleared automacally when the device restarts or at the daily reset me.
Daily Reset Time
The device clears the data in 00:00 each day by default. You can select a me point through
the drop-down list. Aer selecng, the counng data will be automacally cleared at this
me point every day.
You can click Manual Reset to manually trigger a data reset and clear the current people
counng data.
9.
Click Save.
10.
Set arming schedule. See
Set Arming Schedule .
11.
Set linkage method. See
Linkage Method Sengs .
12.
Click Save.
13.
Oponal: Set people counng data uploading parameters.
Click Data Upload to enter the interface. Click Save aer nishing the sengs.
Network Camera User Manual
95