HIKVISION DS-2XC6745G0-IZHS - Page 94

3) Oponal: Click to delete all the seng areas.
4.
Set parameters.
Sensivity
Sensivity stands for the percentage of the body part of an acceptable target that enters the
predened region. Sensivity = 100 - S1/ST × 100. S1 stands for the target body part that goes
across the
predened region. ST stands for the complete target body. The higher the value of
sensivity is, the more easily the alarm can be triggered.
Threshold
It stands for the me of the objects le in the region. Alarm is triggered aer the object is le
and stays in the region for the set me period.
Figure 10-5 Set Rule
5.
Oponal: You can set the parameters of mulple areas by repeang the above steps.
6.
For the arming schedule sengs, refer to Set Arming Schedule . For the linkage method sengs,
refer to Linkage Method Sengs .
7.
Click Save.
Note
The funcon is only supported by certain models. The actual display varies with the models.
Network Camera User Manual
83