WiFi Router • User Guide
2
Jack, ports, and button
Jack, ports and button description
Blinking fast for 3 seconds
A wired device connecting to or disconnected from the
router
Used for WPS negotiation or reset.
WPS: Press the button for 1 to 3 seconds, and enable the WPS
function of the WPS-enabled device within 2 minutes to establish
a WPS connection.
RST: Hold down the button for about 8 seconds and then release
it when the LED indicator blinks fast. The router is reset
successfully.
10/100 Mbps auto-negotiation Ethernet port.
Used as a LAN port by default. Once the IPTV function is enabled, it
can only serve as an IPTV port to connect to a set-top box.
10/100 Mbps auto-negotiation LAN port.
Used to connect devices.
WPS/RST, IPTV/3, 2, 1, WAN, POWER
To Next Page
Loading...
