HIKVISION DS-7100HGHI-K1/R Series

What to do next
You can view DDNS status in Status.
6.2.3 NAT
Two ways are provided for port mapping to realize the remote access via the cross-segment
network, UPnP™ and manual mapping.
Before You Start
Enable the UPnP™
funcon of your router if UPnP™ is required. When the device network working
mode is mul-address, the default device route should be on the same network segment as the
LAN IP address of the router.
Steps
1.
Conguraon → Network → General → NAT .
2. Check Enable.
3. Select Mapping Type as Manual or Auto
Auto The port mapping items are read-only, and the external ports are set by the router
automacally. You can click Refresh to get the latest status of the port mapping.
Manual Select an external port type. Click to edit External Port. You can use the default
external port No., or change it according to actual requirements. External Port
indicates the port No. for port mapping in the router.
The value of the RTSP port No. should be 554 or between 1024 and 65535, while
the value of the other ports should be between 1 and 65535 and the value must
be
dierent from each other. If mulple devices are congured for the UPnP™
sengs under the same router, the value of the port No. for each device should
be unique.
4.
Set the virtual server of your router, including internal source port, external source port, etc.
The virtual server parameters shall be corresponding with your device port.
6.2.4 Ports (More
Sengs)
Set dierent port types to enable relevant funcons as your desire.
Go to Conguraon → Network → General → More Sengs .
Alarm Host IP/Port
The device will send the alarm event or
excepon message to the alarm host when an alarm is
triggered. The remote alarm host must have the client management system (CMS) soware
installed.
Alarm Host IP refers to the IP address of the remote PC on which the CMS soware (e.g.,
iVMS-4200) is installed, and the Alarm Host Port (7200 by default) must be the same as the
alarm monitoring port
congured in the soware.
Digital Video Recorder User Manual
41