“Local”:
Local rights are for local operation, such as the operation using front panel, IR
remote control and RS-485 interface.
PTZ control: Locally control PTZ;
Record: Manual start/stop recording;
Set parameters Setup: Locally setup the DVR parameters;
Log: Locally view the log on DVR;
Utilities: Locally upgrade firmware, format HDD, reboot DVR and shut down
DVR, etc.
“Remote”:
PTZ Control: Remote control PTZ;
Record: Remote manual start/stop recording;
Set parameters Setup: Remote setup the DVR parameters;
Log: Remote view the log on DVR;
Utilities: Remote upgrade firmware, format HDD, reboot DVR and shut down
DVR, etc.
Talk: Client talks with DVR;
Alarm: Remote control DVR alarm output;
Local Video Out: Remote control DVR video output;
Com Control: DVR RS-232
MAC address
This MAC address is not the address of DVR but the address of the PC that
accesses DVR. If you setup this function, only the PC with this MAC address can
access this DVR.
At PC end, in DOS prompt, you can use “ipconfig” command to get the PC MAC
address (6 bytes).
Delete user
In “User Management” interface, you can use [] [] keys to select one user,
then use [] to move “Active Frame” to “Del” button, press [ENTER], in the pop-up
confirmation dialog, press “Confirm” button to delete the selected user and return.
Press “Cancel” or [ESC] to abort deleting. Shown as Fig.5.7 below
To Next Page
Loading...
Need help?
General