EasyManuals Logo

HIKVISION DS-7208HTHI-K2 User Manual

HIKVISION DS-7208HTHI-K2
211 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #170 background imageLoading...
Page #170 background image
Network Video Recorder User Manual
169
Chapter 16 Network Settings
Configure TCP/IP Settings
Purpose
TCP/IP settings must be properly configured before operating the device over network.
Go to System > Network > TCP/IP.
TCP/IP Settings
Select Net-Fault Tolerance or Multi-Address Mode under Working Mode.
Net-Fault Tolerance: The two NIC cards use the same IP address, and you can select the main
NIC to LAN1 or LAN2. By this way, in case of one NIC card failure, the device will automatically
enable the other standby NIC card so as to ensure the normal running of the whole system.
Load Balance: By using the same IP address and two NIC cards share the load of the total
bandwidth, which enables the system to provide two Gigabit network capacity.
Multi-address Mode: The parameters of the two NIC cards can be configured independently.
You can select LAN1 or LAN2 under Select NIC for parameter settings. You can select one NIC
card as default route. And then the system is connecting with the extranet the data will be
forwarded through the default route.
Configure other IP settings as needed.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-7208HTHI-K2 and is the answer not in the manual?

HIKVISION DS-7208HTHI-K2 Specifications

General IconGeneral
Voltage12 V
Product colorBlack
LED indicatorsYes
Channels quantity8 channels
Maximum frame rate30 fps
Audio formats supportedG.711
Maximum video resolution3840 x 2160 pixels
Video compression formatsH.265 Pro+, H.265 Pro, H.264, H.264+, H.265, H.265+
Analog signal format systemNTSC, PAL
Playback resolutions supported8MP/5MP/4MP/3MP/1080p/720p/WD1/4CIF/VGA/CIF
Audio input4
BNC input ports8
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Ethernet interface typeGigabit Ethernet
Supported network protocolsTCP/IP, PPPoE, DHCP, Hik-Connect, DNS, DDNS, NTP, SADP, NFS, iSCSI, UPnP, HTTPS, ONVIF
HDD interfaceSerial ATA
Number of HDDs supported2
Power consumption (max)20 W
Operating temperature (T-T)-10 - 55 °C
Operating relative humidity (H-H)10 - 90 %
Optical drive includedNo
Weight and Dimensions IconWeight and Dimensions
Depth320 mm
Width380 mm
Height48 mm
Weight2000 g

Related product manuals