HIKVISION DS-7616NXI-I2/16P/4S User Manual

Network Video Recorder User Manual
130
A PIR (Passive Infrared) alarm is triggered when an intruder moves within the detector vision field.
The heat energy dissipated by a person, or any other warm blooded creature such as dogs, cats,
etc., can be detected.
Step 1 Go to System > Event > Smart Event.
Step 2 Click PIR Alarm.
Step 3 Select a Camera to configure.
Step 4 Check PIR Alarm.
Step 5 Optionally, check Save VCA Picture to save the captured pictures of PIR alarm.
Step 6 Set the arming schedule. Refer to Chapter 11.1 Configure Arming Schedule.
Step 7 Set the linkage actions. Refer to Chapter 11.2 Configure Alarm Linkage Actions.
Step 8 .Click Apply.
12.14 Enable Smart Search
Purpose
By enabling smart search for IP cameras do not support line crossing and intrusion detection, the
device will analyze line crossing and intrusion events. Supported smart events will be changed after
enabling smart search.
Step 1 Go to System > Event > Smart Event.
Step 2 Check Enable Smart Analysis.
Step 3 Click Yes on popup message box.

HIKVISION DS-7616NXI-I2/16P/4S Specifications

General

Model	DS-7616NXI-I2/16P/4S
Category	Network Hardware
Two-Way Audio	Yes
Decoding Format	H.265+/H.265/H.264+/H.264
PoE	Yes
Input Bandwidth	160 Mbps
Output Bandwidth	160 Mbps
Consumption (without HDD)	≤ 15W
Working Humidity	10% to 90%
Operating Humidity	10% to 90%
Video Input	16 Channel
IP Video Input	16 channels
Video Output	HDMI, VGA
Max Resolution	12 MP
Audio Output	1-ch, RCA
Decoding Capability	16 × 1080p @ 30 fps
Network Interface	1 × RJ45 10/100/1000 Mbps
PoE Ports	16
USB Interface	2 × USB 2.0
Alarm In/Out	4/4
HDD Bays	4
SATA	4 SATA interfaces
Capacity	Up to 10TB per HDD
Power Supply	100 to 240 VAC, 50 to 60 Hz
Working Temperature	-10 °C to 55 °C (14 °F to 131 °F)
Operating Temperature	-10 °C to 55 °C (14 °F to 131 °F)