Network Video Recorder User Manual
176
Operator: The Operator user level has permission of Two-way Audio in Remote
Configuration and all operating permission in Camera Configuration by default.
Guest: The Guest user has no permission of Two-way Audio in Remote Configuration and
only has the local/remote playback in the Camera Configuration by default.
User’s MAC Address: The MAC address of the remote PC which logs onto the device. If it is
configured and enabled, it only allows the remote user with this MAC address to access the
device.
Step 5 Click OK to finish the new user account adding.
Result: In the User Management interface, the added new user is displayed on the list.
Figure 19-6 User List
19.4.2 Set the Permission for a User
For the added user, you can assign the different permissions, including the local and remote
operation for the device.
Step 1 Go to System > User.
Step 2 Select a user from the list and then click the button to enter the permission settings
interface.
To Next Page
Loading...
Need help?
General
