Network Video Recorder User Manual
11
Figure 1-11 Add Network Camera
4. Optional: Check Use Channel Default Password to use the default password to add the camera.
5. Optional: Check Enable IP Camera Time Sync to synchronize the time of the connected IP
camera automatically. For details, refer to Configure IP Camera Time Sync.
6. Optional: Check Use Default Port to use the default management port to add the camera. For
SDK service, the default port value is 8000. For enhanced SDK service, the default value is 8443.
Note
The function is only available when you use HIKVISION protocol.
7. Optional: Check Verify Certificate to verify the camera with certificate. The certificate is a form
of identification for the camera that provides more secure camera authentication. It requires to
import the network camera certificate to the device first when you use this function. For details,
refer to Import Network Camera Certificate.
Note
The enhanced SDK service is only available when you use HIKVISION protocol.
8. Optional: Click Search to search other network cameras.
9. Optional: Click Continue to Add to add other network cameras.
10. Click Add.
1.4.3 Add Network Camera Through PoE
The PoE interfaces enable the device system to pass electrical power safely, along with data, on
Ethernet cabling to the connected PoE cameras. Supported PoE camera number varies with device
module. If you disable the PoE interface, you can also connect to the online network cameras. And
To Next Page
Loading...
Need help?
General
Weight and Dimensions
