HIKVISION DS-E04NI-Q1 - Page 39

Figure 5-11 Line Crossing Detecon
2. Select a camera.
3. Turn on Enable.
4. Set line crossing
detecon rules and detecon areas.
1) Set Arming Area. Up to 4 arming areas are selectable.
2) Select
Direcon as A<->B, A->B, or A<-B.
A<->B
Only the arrow on the B side shows. An object crossing a congured line in both direcons
can be detected and trigger alarms.
A->B
Only an object crossing the congured line from the A side to the B side can be detected.
B->A
Only an object crossing the congured line from the B side to the A side can be detected.
3) Set Sensivity. The higher the value is, the easier the detecon alarm will be triggered.
4)
Oponal: Set Target Detecon as Human or Vehicle to discard alarms which are not triggered
by human body or vehicle.
5) Click Draw Area, and set two points in the preview window to draw a virtual line.
5. Set the arming schedule. Refer to for
Congure Arming Schedule for details.
6. Set the linkage
acons. Refer to Congure Alarm Linkage Acon for details.
7. Click Apply.
Intrusion
Detecon
Intrusion detecon detects people, vehicles, or objects that enter and loiter in a pre-dened virtual
region.
Steps
1. Go to Conguraon → Camera → Event → Intrusion .
Network Video Recorder User Manual
26