To Next Page

To Previous Page

Enable Card Reader

Enable the card reader's funcon.

Authencaon

Select an authencaon mode according to your actual needs from the drop-down list.

Recognion Interval

If the interval between card presenng of the same card is less than the congured value, the

card

presenng is invalid. The interval me range is from 0 to 255 seconds (When set to 0, it

means that recognion interval is not enabled, and the same authencaon can be used for

unlimited mes).

Authencaon Interval

You can set the authencaon interval of the same person when authencang. The same

person can only

authencate once in the congured interval. A second authencaon will be

failed.

Max. Authencaon Failed Aempts Alarm/Alarm of Max. Failed Aempts

Enable to report alarm when the card reading aempts reach the set value.

Enable Tampering Detecon

Enable the an-tamper detecon for the card reader.

Enable Card No. Reversing

The read card No. will be in reverse sequence aer enabling the funcon.

Communicaon with Controller Every (s)

When the access control device cannot connect with the card reader for longer than the set

me, the card reader will turn oine automacally.

Max. Interval When Entering Password (s)

When you entering the password on the card reader, if the interval between pressing two

digits is longer than the set value, the digits you pressed before will be cleared automacally.

Set Privacy Parameters

Set the event storage type, picture upload and storage parameters, and the picture clearing

parameters.

Tap

Conguraon → General Sengs → Privacy .

DS-K1T6QT-F43 Series Face Recognion Terminal User Manual

HIKVISION DS-K1T6QT-F43EW User Manual

Questions and Answers: