HIKVISION DS-KD-KK

Figure 6-25 Elevator Control
2. Check to enable elevator control
funcon.
3. Select an Elevator No., and select an elevator controller.
4. Select Interface Type.
5. Enter Negave Floor Capacity, and select Alarm Receiver
Type.
6. Enter the elevator controller's Server IP Address, Port No.,
User Name, and Password.
7. Click Save to enable the
sengs.
Note
●
Up to 4 elevator controllers can be connected to one door
staon.
●
Up to 10 negave oors can be added.
●
Make sure the interface types of elevator controllers, which
are connected to the same door staon are consistent.
6.4.10 Theme Sengs
Set the adversement on the main page of the device.
Steps
1. Click
Conguraon → Theme to enter the sengs page.
54