HIKVISION DS-KD-KK

Steps
1. Click Access Control → Elevator Control Parameter to enter
the sengs page.
Figure 7-23 Elevator Control
2. Check to enable elevator control funcon.
3. Select an Elevator No., and select an elevator controller.
4. Select Interface Type.
5. Enter
Negave Floor Capacity, and select Alarm Receiver
Type.
6. Enter the elevator controller's Server IP Address, Port No.,
User Name, and Password.
7. Click Save to enable the
sengs.
Note
●
Up to 4 elevator controllers can be connected to one door
staon.
●
Up to 10 negave oors can be added.
●
Make sure the interface types of elevator controllers, which
are connected to the same door staon are consistent.
7.4 Organizaon Management
On the main page of the Client Soware, click
PersonalManagement to enter the conguraon page.
7.4.1 Add
Organizaon
Steps
1. In the organizaon list on the le, click +Add.
2. Enter the Organizaon Name as desired.
3. Click OK to save the adding.
4. Oponal: You can add mulple levels of organizaons
according to the actual needs.
73