Panic Alarm Station User Manual
21
When the device accesses the network through the domain name, you need to configure the
correct and available DNS server IP address.
The device supports 2 DNS address.
Click to enter the Remote Configuration page, go to Network → DNS, set the DNS server IP
address and click Save to save the settings.
DNS Setting Page
When DHCP is enabled, the DNS cannot be set.
Enable the UPnP function, and you don't need to configure the port mapping for each port, and
the device is connected to the Wide Area Network via the router.
Steps
Universal Plug and Play (UPnP™) is a networking architecture that provides compatibility among
networking equipment, software and other hardware devices. The UPnP protocol allows devices to
connect seamlessly and to simplify the implementation of networks in the home and corporate
environments.
1. Click to enter the Remote Configuration page, go to Network → NAT.
To Next Page
Loading...
Need help?
General
