Panic Alarm Station User Manual
30
Output Delay(s)
The output delay time, can be set from 0 to 2000s. After the zone event is triggered, the relay
will turn off the relay output after the output delay time is ended.
3. Click Save.
4. Optional: Click Copy to..., you can copy the relay settings to other relays.
Configure the call waiting parameters, include the maximum ring duration and waiting time.
Steps
1. Click to enter the Remote Configuration page, go to Output Settings → Waiting.
Call Waiting Settings Page
2. Set the call waiting parameters.
Calling Duration
The playback time of the calling tone when calling, can be set from 40 s to 80 s.
Waiting Time
The extended playback time of the prompt tone based on the maximum ring time when
calling the center station and pressing the call waiting button, can b set from 10 seconds to
60 s.
3. Click Save.
Steps
1. Click to enter the Remote Configuration page, go to Output Settings → Voice Prompt.
To Next Page
Loading...
Need help?
General
