HIKVISION DS-PHA64-W4M - Module; 4.2.3 Area Settings; Basic Settings

Note
Aer congurated, you can check the company name and phone number on the keypad LCD
screen.
8. Click OK.
Module
The wired module is connected to the control panel via RS-485 wiring. You can refer to the Hybrid
Control Panel Quick Start Guide for details.
Steps
1. In the client
soware, select the device on the Device Management page and click , or enter
the device IP address in the address bar of the web browser and log in.
2. Click
Conguraon → Device Management → Module Informaon to enter the page.
3. Select the Module Type.
4. Click
to enter the module sengs page.
5. Set the module name.
6. Click OK.
7.
Oponal: Click to delete the module.
4.2.3 Area
Sengs
Basic Sengs
You can link zones to the selected area.
Steps
1. In the client soware, select the device on the Device Management page and click , or enter
the device IP address in the address bar of the web browser and log in.
2. Click
Conguraon → Area Management → Basic Sengs to enter the page.
Hybrid Security Control Panel User Manual
38