HIKVISION DS-PHA64-W4M - 4.3 Use Mobile Client

When the funcon is enabled, if the device is armed, the indicator will be on all the me. And if
the device is disarmed, the indicator will be o.
Note
Only -P model supports this funcon.
Prompt Fault When Arming
If the device applies EN standard, by default, the funcon is disabled. In this case, the device will
not prompt faults during the arming procedure.
Note
Only -P model supports this funcon.
Enable Early Alarm
If you enable the funcon, when the zone is armed and the zone is triggered, the alarm will be
triggered aer the delay me.
Note
The early alarm will be taken eect only aer the delayed zone is triggered.
Delay
When the early alarm funcon is enabled, you should set the delay me. The alarm will be
triggered aer the congured delay me.
Fault Check
The system determines whether to check the faults listed on the page. The system will only check
the fault that is selected.
Click
Conguraon → System → System Opons → Fault Check to enter the Advanced Sengs
page.
Hybrid Security Control Panel User Manual
55