Network Video Recorder Quick Start Guide
21
Chapter 2 Installation and Connections
2.1 Installation
During installation of the NVR:
Use brackets for rack mounting.
Ensure ample room for audio and video cables.
When routing cables, ensure that the bend radius of the cables are no less than five times than
its diameter.
Connect the alarm cable.
Allow at least 2cm (≈0.75-inch) of space between racks mounted devices.
Ensure the NVR is grounded.
Environmental temperature should be within the range of -10° C to +55° C (+14° F to +131° F).
Environmental humidity should be within the range of 10% to 90%.
2.2 Hard Disk Installation
2.2.1 iDS-96000NXI-I16/24(B) Series
Purpose:
We take the example of iDS-96000NXI-I16(B) to describe HDD installation
Before you start:
Disconnect the power from the NVR before installing a hard disk drive (HDD). A factory
recommended HDD should be used for this installation.
Step 1 Unlock the front panel with the panel key.
Figure 2-1 Unlock the Panel
To Next Page
Loading...
Need help?
General
