HIKVISION iDS-TCM403-B/0832

3.
Oponal: Select the violaon type(s) to be detected, and set the corresponding parameters.
Refer to Set Violaon and Incident Detecon for details.
4.
Set the lane parameters. Refer to Set Linked Lane Parameters for details.
5.
Set
connuous capture parameters. Refer to Set Connuous Capture Parameters for details.
6.
Set speed limit parameters. Refer to
Set Lane Speed Limit Parameters for details.
7.
Link supplement light(s) to the
specic lane(s). Refer to Set Supplement Light Linkage for details.
8.
Set radar parameters. Refer to Set Radar Parameters for details.
9.
Oponal: Check the other lane(s) to copy the same sengs.
10.
Draw lane lines.
1) Click Draw Lane Line.
2) Select the default lane lines and right border line, and drag the two end points of the line or
drag the whole line to adjust its
posion according to the actual scene.
3) Click OK.
Figure 1-4 Draw Lane Line
Network Trac Camera Conguraon Manual
6