HIKVISION iDS-TCM403-B/0832

1.6.5 Set Informaon Overlay
Set Single Picture Overlay
If you want to overlay informaon on the captured single pictures, set capture overlay.
Steps
Note
The supported parameters vary with dierent models. The actual device prevails.
1.
Go to Conguraon → Capture → Capture Parameters → Text Overlay .
2.
Select single picture channel.
3.
Check Capture Picture Overlay.
Figure 1-18 Set Single Picture Overlay
4.
Set the percentage, front size, color, overlay posion, etc.
Percentage
It is the percentage that the overlaid informaon occupies on the picture. For example, if you
set the percentage to 50, the overlaid informaon in a row will occupy up to half of the image
width, and the excess content will be overlaid from a new line.
Overlay Number Zeroizing
When the overlaid number digits are smaller than the
xed digits, 0 will be overlaid before
the overlaid number. E.g., the xed digits for lane No. is 2. If the lane No. is 1, 01 will be
overlaid on the picture.
Overlay Plate Close-up
Network Trac Camera Conguraon Manual
35