HIKVISION iDS-TCM403-B/0832

Chapter 2 Radar Detecon
Radar is used to detect the target and link the capture. Set radar detecon parameters before
capturing vehicle pictures.
Before You Start
Select the
applicaon mode as RS-485 Radar, and select Radar Type as Mul-Lane Radar.
Steps
Note
The funcon varies with dierent models. The actual device prevails.
1.
Click Radar.
2.
View the radar informaon.
Soware Version
The soware version of the radar.
Radar Status
The current radar status. The radar can be normally used in normal status. If the radar is in
upgrading status, do not reboot the device. Refresh the interface every one minute, and the
status can be restored to normal.
3.
Check Debug Mode to set the parameters.
Figure 2-1 Set Radar Parameters
1) Set construcon parameters.
Construcon Height
Set the construcon height of the radar according to construcon at the actual scene.
Network Trac Camera Conguraon Manual
46