HIKVISION iDS-TCM403-B/0832

3.
Oponal: Select the violaon type(s) to be detected, and set the corresponding parameters.
Refer to Set Violaon and Incident Detecon for details.
4.
Set connuous capture parameters. Refer to Set Connuous Capture Parameters for details.
5.
Set scene and mode parameters. Refer to
Set Scene Mode for details.
6.
Set the lane parameters. Refer to
Set Linked Lane Parameters for details.
7.
Set speed limit parameters. Refer to
Set Lane Speed Limit Parameters for details.
8.
Link supplement light(s) to the specic lane(s). Refer to Set Supplement Light Linkage for details.
9.
Set radar parameters. Refer to Set Radar Parameters for details.
10.
Oponal: Check the other lane(s) to copy the same sengs.
11.
Draw lane lines.
1) Click Draw Lane Line.
2) Set the property of the lane lines.
3) Select the default lane lines, right border line, and trigger line, and drag the two end points
of the line or drag the whole line to adjust its
posion according to the actual scene.
4) Click OK.
Network Trac Camera Conguraon Manual
9