HIKVISION iDS-TCM403-B/0832

Figure 1-9 Set Smart Monitoring Capture
3.
Set smart mode parameters. Refer to Set Scene Mode for details.
4.
Set
connuous capture parameters. Refer to Set Connuous Capture Parameters for details.
5.
Set the lane parameters. Refer to Set Linked Lane Parameters for details.
6.
Oponal: Check the other lane(s) to copy the same sengs.
7.
Draw lane lines.
1) Click Draw Lane Line.
2) Select the default lane lines, trigger line, and right border line, and drag the two end points of
the line or drag the whole line to adjust its
posion according to the actual scene.
3) Oponal: Click Redraw Lane Line to redraw the lines.
4) Click OK.
Network Trac Camera Conguraon Manual
14