Network Traffic Camera • User Manual
25
If you set the port number as 443 and the IP address is 192.168.1.64, you may access the device by
inputting https://192.168.1.64:443 via the web browser.
The HTTPS port can be only configured through the web browser.
Step 1 Go to Configuration > Device Configuration > System Configuration > HTTPS.
Figure 6-6 HTTPS Configuration
Step 2 Create and install the certificate.
OPTION 1: Create private certificate.
1) Click Create private certificate.
2) Click Create and the following message box pops up as below.
Figure 6-7 Create Private Certificate
3) Enter the parameters.
4) Click OK to save the settings.
OPTION 2: Signed certificate is available. Start the installation directly.
1) Click Signed certificate is available. Start the installation directly.
2) Click View to find the saving path of the certificate.
3) Click Install to install the certificate.
To Next Page
Loading...
Need help?
General
