Network Traffic Camera • User Manual
57
10.5 Configure ICR
Purpose:
IR Cut Filter is used to block or reflect infrared wavelengths but pass visible light. This series of
cameras support auto switch of ICR to realize the 24-hour surveillance.
ICR configuration is not supported by all camera models of this series.
Step 1 Go to Configuration > Device Configuration > Image Parameters > ICR.
Step 2 Select ICR Mode. Do not Switch, Auto-switch, Manual Switch, and Scheduled Switch are
selectable.
Do not switch: The ICR always stays in day mode by default.
Auto Switch: The ICR switches according to the brightness. Adjust Threshold from 0 to 100.
Figure 10-5 Auto-Switch
Manual Switch: If you set the ICR mode as Manual Switch, it offers you an option to select day
or night.
Figure 10-6 Manual Switch
Scheduled Switch: The ICR switches according to the configured time schedule. You can set
the Start Time and End Time of Day/Night Mode according to local time.
Figure 10-7 Scheduled Switch
Step 3 Click Save to save the settings.
10.6 Configure Light Calibration
Purpose:
To Next Page
Loading...
