Hill-Rom CareAssist P1170 User Manual

4.33 Power Cord (B Model and Newer Beds)
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 100 CareAssist® and CareAssist® ES Bed Service Manual (MAN330 REV 4)
12. Remove the two screws (K) that attach the power cord (H) to the bed (L).
13. Remove the power cord (H) from the bed (L).
Replacement
1. Put the mark (M) on the power cord (H) so the edge of the mark (M) is
even with the edge of the wire guide (J).
2. Put the other mark (M) on the power cord (H) so the edge of the mark (M)
is even with the enclosure entrance on the power supply (F).
3. Do the removal procedure in reverse order.
4. Do the “Function Checks” on page 2-5.

Hill-Rom CareAssist P1170 Specifications

General

Model	CareAssist P1170
Type	Hospital Bed
Weight Capacity	500 lbs (227 kg)
Trendelenburg Position	Yes
Reverse Trendelenburg Position	Yes
Battery Backup	Yes
Frame Material	Steel
Knee Gatch	Yes
Head Section	Adjustable
Foot Section	Adjustable
CPR Release	Yes
Overall Width	39 in
Height Range	15 in to 30 in
Side Rails	Yes
Power Source	Electric
Mattress Type	Foam or Air
Patient Controls	Yes
Wheels	Locking Casters
Warranty	Varies
Overall Length	88 inches (223.5 cm)