Hill-Rom CareAssist P1170 User Manual

Electrical System Wiring Diagram
Chapter 3: Theory of Operation
CareAssist® and CareAssist® ES Bed Service Manual (MAN330 REV 4) Page 3 - 21
3
Electrical System Wiring Diagram
Figure 3-1. SideCom® Communication System (A through E Model Beds)
Figure 3-2. Siderail Interface P.C. Board—P/N 72207 and 71514
(Beds without the
SafeView™ Alerts or the NaviCare® Patient Safety Module)
Figure 3-3. Caregiver Control
Figure 3-4. Caregiver Signal Conditioning
Figure 3-5. Bed Control Board Power and Phase Control
Figure 3-6. Bed Control Board Power Management
Figure 3-7. Bed Control Board Battery Management
Figure 3-8. Bed Control Board Clock and Divider
Figure 3-9. Bed Control Board Relay, FET and Drivers
Refer to fold-out FO 3-1 at the rear of this manual.
Refer to fold-out FO 3-2 at the rear of this manual.
Refer to fold-out FO 3-3 at the rear of this manual.
Refer to fold-out FO 3-4 at the rear of this manual.
Refer to fold-out FO 3-5 at the rear of this manual.
Refer to fold-out FO 3-6 at the rear of this manual.
Refer to fold-out FO 3-7 at the rear of this manual.
Refer to fold-out FO 3-8 at the rear of this manual.
Refer to fold-out FO 3-9 at the rear of this manual.

Hill-Rom CareAssist P1170 Specifications

General

Model	CareAssist P1170
Type	Hospital Bed
Weight Capacity	500 lbs (227 kg)
Trendelenburg Position	Yes
Reverse Trendelenburg Position	Yes
Battery Backup	Yes
Frame Material	Steel
Knee Gatch	Yes
Head Section	Adjustable
Foot Section	Adjustable
CPR Release	Yes
Overall Width	39 in
Height Range	15 in to 30 in
Side Rails	Yes
Power Source	Electric
Mattress Type	Foam or Air
Patient Controls	Yes
Wheels	Locking Casters
Warranty	Varies
Overall Length	88 inches (223.5 cm)