8 English
5.3 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out toward the rear.
5.4 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the rotary hammer drill.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping
band is engaged in the groove in the tool.
1. Release the side handle clamping band by turning the handle grip.
2. From the front, slide the depth gauge into the 2 guide holes.
3. Tighten the side handle clamping band by turning the handle grip.
Printed: 03.02.2017 | Doc-Nr: PUB / 5329716 / 000 / 00
To Next Page
Loading...
