10 English
5.7 Inserting the tool
1. Lightly grease the connection end of the accessory tool.
◁ Use only genuine Hilti grease. Using the wrong grease can result in damage to the tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
3. After fitting the accessory tool, grip it and pull it in order to check that it is securely engaged.
◁ The product is ready for use.
5.8 Removing the accessory tool
▶ Pull the chuck back as far as it will go and remove the accessory tool.
5.9 Overhead work
▶ Fit the DCD dust control ring for overhead work.
Printed: 03.02.2017 | Doc-Nr: PUB / 5329716 / 000 / 00
To Next Page
Loading...
