Hilti TE 6-A22 - Intended Use; Lithium­ion Battery Status Display; Items Supplied; Technical Data

6 English
=
Insert tool unlocking device
%
Depth gauge
&
Function selector switch
(
Forward / reverse selector switch with
safety lock
)
Control switch
+
Grip
§
Battery release buttons
/
Charge status and fault display (Li-ion
battery)
:
Battery
∙
Connection for the TE DRS-6-A(02) dust
removal module
$
Side handle
£
Light to illuminate the work area
3.2 Intended use
The product described is a cordless rotary hammer drill. It is designed for drilling in steel, wood and masonry,
for hammer-action drilling in concrete and masonry, and for driving and removing screws. The product can
also be used for light chiseling work on masonry and surface finishing on concrete.
▶ Use only Hilti lithiumion batteries of the B 22 series with this product.
▶ Use only the Hilti lithium-ion batteries from the B22 series for this product.
3.3 Lithiumion battery status display
The charge status of the Li-ion battery and malfunctions of the power tool are indicated by the display on
the Liion battery. The charge status of the Liion battery is displayed after pressing one of the two battery
release buttons.
Status Meaning
4 LEDs light up. • Charge status: 75 % to 100 %
3 LEDs light up. • Charge status: 50 % to 75 %
2 LEDs light up. • Charge status: 25 % to 50 %
1 LED lights up. • Charge status: 10 % to 25 %
1 LED blinks. • Charge status: < 10 %
Note
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the battery display LEDs blink, please observe the instructions
given in the Troubleshooting section.
3.4 Items supplied
Rotary hammer, side handle, depth gauge, operating instructions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com.
4 Technical data
4.1 Rotary hammer
TE 6A22
Rated voltage
21.6 V
Weight in accordance with EPTA procedure 01
3.7 kg
Rated speed under no load
1,050 /min
Drilling diameter range in concrete/masonry (hammer drilling)
5 mm …20 mm
Drilling diameter range in wood (solid)
3 mm …20 mm
Drilling diameter range in metal (solid-head drill bit)
3 mm …13 mm
4.2 Noise and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the power tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
Printed: 03.02.2017 | Doc-Nr: PUB / 5329716 / 000 / 00