How to release drill bit from Hilti Tools?
If the drill bit cannot be released from your Hilti Tools, the chuck might not be pulled back fully. To solve this, pull the chuck back as far as it will go and then remove the tool.
What to do if my Hilti Tools rotary hammer doesn’t achieve full power?
If your Hilti Tools rotary hammer isn’t achieving full power, there are a couple of potential causes. First, the gauge (cross section) of the extension cord conductors might be inadequate, so try using an extension cord with an adequate conductor cross section. Second, the control switch may not be fully pressed. Make sure to press the control switch as far as it will go.
How to fix no hammering action on my Hilti Tools?
If there is no hammering action on your Hilti Tools, it could be due to a couple of reasons. One possibility is that the power tool is too cold. In this case, bring the tip of the drill bit into contact with the working surface, switch the rotary hammer on, and allow it to run. Repeat if necessary until the hammering mechanism begins to operate. Alternatively, the function selector switch might be set to “Drilling without hammering”. If so, set the function selector switch to the “Drilling with hammering action” (hammer drilling) position.
Why Hilti Tools drill bit does not rotate?
If the drill bit on your Hilti Tools does not rotate, the function selector switch may not be engaged or is in the “Chiseling” or “Chisel adjustment” position. To resolve this, set the function selector switch to “Drilling without hammering” or “Hammer drilling”.
General| Brand | Hilti |
|---|---|
| Model | TE 6-CL |
| Category | Rotary Hammer |
| Language | English |
To Next Page
