Hilti TE 60-A36 - 3.8 Items supplied; 4 Technical data; 4.1 Noise information and vibration values in accordance with EN 62841; 5 Operation

*2202100*
2202100 English 7
3.8 Items supplied
Combihammer, side handle, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group | USA: www.hilti.com
4 Technical data
TE 60-A36
Rated voltage
36 V
Weight in accordance with EPTA procedure 01
8.1 kg
Single impact energy in accordance with EPTA procedure 05
8.1 J
Hammer drill bits, Ø
12 mm … 40 mm
Breach bits, Ø
40 mm … 80 mm
Percussion core bits, Ø
45 mm … 100 mm
PCM diamond core bits, Ø
42 mm … 102 mm
Drill bits for metal, Ø
10 mm … 20 mm
Drill bits for wood, Ø
10 mm … 32 mm
Chuck
TEY
4.1 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise emission values in accordance with EN 60745
TE 60-A36
Sound pressure level (LpA)
98 dB
Uncertainty for the sound pressure level (KpA)
3 dB
Sound power level (LWA)
109 dB
Uncertainty for the sound power level (KWA)
3 dB
Total vibration in accordance with EN 60745
TE 60-A36
Hammer drilling in concrete (a
h, HD
)
8.3 m/s²
Uncertainty (K)
1.5 m/s²
Chiseling in concrete (a
h, CHeq
)
6.7 m/s²
Uncertainty (K)
1.5 m/s²
5 Operation
5.1 Preparations at the workplace
Switch the product off or remove the battery before making adjustments or changing accessories.