Hilti TE 60-A36 - 5.1.6 Inserting the battery; 5.2 Types of work; 5.2.1 Drilling with hammering action (hammer drilling); 5.2.2 Drilling without hammer action

*2202100*
2202100 English 9
5.1.6 Inserting the battery 6
WARNING
Electrical hazard! Risk of short circuiting.
▶ Before inserting the battery, check to ensure that the battery terminals and the contacts on the
combihammer are free from foreign objects.
WARNING
Risk of injury! Hazard presented by a falling battery.
▶ A falling battery may present a risk of injury to yourself and others. Check that the battery is securely
seated in the combihammer.
1. Push the battery into the battery holder until it engages with an audible click.
2. Check that the battery is seated securely.
5.2 Types of work
CAUTION
Risk of injury! Loss of control over the combihammer.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping band is
engaged in the groove provided on the tool.
Observe the safety instructions and warnings in this documentation and on the product.
5.2.1 Drilling with hammering action (hammer drilling)
1.
Set the function selector switch to this symbol: .
2. Set the desired power level.
3. Press the drill bit against the work surface.
4. Press the control switch.
▶ The product starts.
5.2.2 Drilling without hammer action
Drilling without hammering action is possible when accessory tools with a special connection end
are used. Accessory tools of this kind are available from Hilti. Alternatively, when the keyless quick-
release chuck is fitted, smooth-shank drill bits for wood or steel, for example, can be used to drill
without hammering.
▶
Set the function selector switch to this symbol: .
5.3 Chisel positioning 7
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to “Chisel positioning”. Turn the function selector
switch until it engages in the “Chiseling” position.
The chisel can be set to 24 different positions (in 15° increments). This ensures that flat chisels and
shaped chisels can always be set to the optimum working position.
1.
Set the function selector switch to the "Chisel positioning” position .
2. Turn the chisel to the desired position.
3.
Set the function selector switch to this symbol: until it engages.
▶ The product is ready for use.
5.3.1 Chiseling
▶
Set the function selector switch to the "Chiseling" position .