4
Specific safety rules and symbols
Hold tool by insulated gripping surfaces when per-
forming an operation where the cutting tool may con-
tact hidden wiring or its own cord.Contact with a "live"
wire will make exposed metal parts of the tool "live" and
shock the operator.
Wear ear protectors when using the tool for
extended periods. Prolonged exposure to high
intensity noise can cause hearing loss.
Use the tool only for purposes for which it is designed.
Failure to do so may result in electric shock, damages
to property and/or serious personal injury.
Always hold tool in both hands when it is in use.Always
use the side handle.Ensure that the side handle is fit-
ted correctly and tightened securely .Hold the side
handle at its outer end when drilling and pay atten-
tion at all times.The drill bit may become stuck anytime,
which may result in the tool twisting if it is not properly
held.
Unplug tool immediately if supply cord becomes
damaged during working.Have supply cord replaced
by a qualified electrician. Damaged supply cords pre-
sent a risk of fire and/or electric shock.
Never operate the tool when it is dirty or wet. Dirt/dust
or dampness on the surface of the tool make it slippery
and difficult to hold and may, under unfavourable con-
ditions, present a risk of electric shock.
Ensure that the insert tools are equipped with the appro-
priate connection end for the chuck system in use and
that they are locked in position correctly in the chuck.
Inserting tools with a different connection end will result
in malfunction and damage to the tool and may even
cause injury by breaking parts. Incomplete insertion may
result in insert tool falling out of chuck, causing dam-
age or injury to persons.
Keep electric tools in a secure place.
Electric tools, when not in use, should be locked away
in a dry place, out of the reach of children.
Symbols used on the tool:
V ............................ volts
~ ............................ alternating current
Hz ............................ hertz
W ............................ watts
A ............................ amperes
n
0
............................ no load speed
n ............................ speed under normal load
/min ............................ revolutions per minute
∅ ............................ diameter
Z ............................ double insulated
Functional description
The TE2 / TE2-S / TE2-M is an electrically powered rotary
hammer with pneumatic hammering mechanism designed
for professional use.
The following items are supplied: power tool, (quick-
release chuck TE2-M), operating instructions, grease,
toolbox.
The following conditions must always be observed
when the tool is in use:
– The tool must be connected to an alternating current
electric supply in compliance with the information
given on the type plate.
– The tool is for hand-held use only.
– The tool must not be used in places where the sur-
rounding conditions may present a risk of explosion.
Main features of the tool
– Electrical protection class II (double insulated) Z
– Mechanical torque-limiting clutch
– Grip and side handle with vibration absorption
– TE-C chuck with twist lock
– TE-C insert tool system
– Variable speed switch
– Drilling modes
– Gearing and hammering mechanism with perma-
nent grease lubrication
– Pivotable side handle
– Mechanical depth gauge
– Interface for quick-release chuck (TE2-M)
– Precision hammering action (TE2-S / TE2-M)
– High spindle speed without hammering action
(TE2-M)
To Next Page
Loading...
