1.2 Explanation of the pictograms and other
information
Warning signs
General
warning
Warning:
electricity
Obligation signs
Wear eye
protection
Wear a hard
hat
Wear ear
protection
Wear
protective
gloves
Wear
breathing
protection
Symbols
Read the
operating
instructions
before use.
Return waste
material for
recycling.
Drilling
without
hammering
Hammer
drilling
Chiseling Chisel position
adjustment
Volts Amps
Watts Alternating
current
Hertz Rated speed
under no load
Revolutions
per minute
Diameter Double
insulated
Reverse
rotation
Forward
rotation
1 These n umbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out
cover pages. Keep these pages open while studying
the operating instructions.
In these operating instructions, the designation “the
power tool” always refers to the TE 7-C rotary ham-
mer.
Location of identification data on the power tool
The type designation can be found on t he type iden-
tification plate and the serial number on the side of
the motor housing. Make a note of this data in your
operating instructions and always refer to i t when
making an enquiry to your Hilti representative or
service department.
Type:
Serial no.:
2. Description
2.1 Use of the product as directed
The power tool is an electrically-powered rotary hammer with pneumatic hammering mechanism.
The power tools are designed for drilling in concrete, masonry, gypsum board (drywall), wood, plastic and
metal. The power tool can also be used for light chiseling work on masonry and surface finishing on concrete.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
The power tool is designed for professional use. The power tool may be operated, serviced and repaired
only by authorized, trained personnel. This personnel must be informed of any special hazards that may be
encountered.
en
16
To Next Page
Loading...
