Recommended minimum conductor cross section and max. cable lengths
Conductor cross sec-
tion
1.5 mm² 2.5 mm² 3.5 mm² 14 AWG 12 AWG
Mains voltage 100V 50 m
Mains voltage 110-120
V
30 m 50 m
100 ft 150 ft
Mains voltage 220-240
V
75 m 100 m
Do not use extension cords with 1.25 mm² or 16 AWG conductor cross sections.
2.9 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this
application.
2.10 Using a generator or transformer
This power tool may be powered by a generator or transformer which fulfills the following conditions: The unit
must provide a power output in watts of at least twice the value printed on the rating plate on the power tool.
The operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in
the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation
andstartingboost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching
other power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in
damage to the power tool.
3. Insert tools, accessories
Chucks TE‑CCLICK
Hammer drill bits Ø 5to28mm
Forming and installation drill bits Ø 5to20mm
Lightweight percussion core bits Ø 25 to 68 mm
Multipurpose hole saws Ø 25 to 82 mm, hexagonal
Pointed chisel
C-type connection end
Flat chisel
C-type connection end
Shaped chisels C-type connection end
Anchor-setting tools
C-type connection end
Quick-release chuck for wood and metal drill bits
For smooth or hex. shank
Key-type chuck With smooth or hex. shank
Wood drill bits Ø 3to20mm
Metal drill bits Ø Max. 13 mm
Metal drill bits / stepped drill bits Ø 5to22mm
Dust module
TE DRS-M
Angular chuck
C-type connection end
en
18
To Next Page
Loading...
