4. Technical data
NOTE
The power tool is available in various voltage ratings. Please refer to the type identification plate for details of
the power tool’s voltage and power rating.
Power tool TE 7‑C
Rated power input Rated voltage 100 V: 680 W
Rated voltage 110 V: 660 W
Rated power input 720 W
Rated current input Rated voltage 110 V: 6.3 A
Rated voltage 120 V: 6.3 A
Rated voltage 127 V: 6 A
Rated voltage 220 V: 3.5 A
Rated voltage 230 V: 3.3 A
Rated voltage 240 V: 3.2 A
Mains frequency
50 to 60 Hz
Weight of power tool
3.2 kg
Dimensions (L x W x H) 341 mm x 86 mm x 217 mm
Drilling speed without hammering 0 to 900 r.p.m.
Hammerdrillingspeed 740r.p.m.
Single impact energy
2.6 J
Noise and vibration information (measured in accordance with EN 60745):
Typical A-weighted sound power level 100 dB (A)
Typical A-weighted emission sound pressure level.
Wear ear protection!
89 dB (A)
Uncertainty for thegiven sound level as per EN60745
3dB(A)
Typical weighted vibration at the grips 10 m/s²
Other information about the power tool
Chucks TE‑CCLICK
Drilling performance in medium-hard concrete
Diameter 16 mm: 56 cm³/min
Protection class as per EN Protection class II (double insulated) as perEN 60745
Interference immunity
As perEN 55014‑2
Radio and television interference suppression
As perEN 55014‑1
5. Safety rules
5.1 General safety rules
WARNING! Read all instructions! Failure to follow all
instructions listed below may result in electric shock,
fire and/or serious injury. The term “power tool” in
all of the warnings listed below refers to your mains-
operated (corded) power tool or battery-operated
(cordless) power tool. SAVE THESE INSTRUCTIONS
5.1.1 Work area
a) Keep work area clean and well lit. Cluttered and
dark areas invite accidents.
b) Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable
en
19
To Next Page
Loading...
