1 Safety manual HIMatrix
Page 8 of 72 HI 800 023 E Rev. 1.01
The manual distinguishes among the different variants using:
Separated chapters
Tables differentiating among the versions, e.g., versions beyond 7, or prior to version 7
i
Projects created with ELOP II Factory cannot be edited with SILworX, and vice versa!
i
This manual usually refers to compact controllers and remote I/Os as devices, and to the
plug-in cards of a modular controller as modules.
1.2 Target Audience
This document addresses system planners, configuration engineers, programmers of
automation devices and personnel authorized to implement, operate and maintain the
devices and systems. Specialized knowledge of safety-related automation systems is
required.
1.3 Formatting Conventions
To ensure improved readability and comprehensibility, the following fonts are used in this
document:
Bold:
To highlight important parts
Names of buttons, menu functions and tabs that can be clicked and
used in the programming tool.
Italics:
For parameters and system variables
Courier
Literal user inputs
RUN Operating state are designated by capitals
Chapter 1.2.3
Cross references are hyperlinks even though they are not particu-
larly marked. When the cursor hovers over a hyperlink, it changes its
shape. Click the hyperlink to jump to the corresponding position.
Safety notes and operating tips are particularly marked.
1.3.1 Safety Notes
The safety notes are represented as described below.
These notes must absolutely be observed to reduce the risk to a minimum. The content is
structured as follows:
Signal word: danger, warning, caution, notice
Type and source of danger
Consequences arising from the danger
Danger prevention
SIGNAL WORD
Type and source of danger!
Consequences arising from the danger
Danger prevention
To Next Page
Loading...
Need help?
General
