41
Installing a Battery Pack
DANGER
To operate the instrument or a wireless module on battery power, use
only the Z1007 Battery Pack.
Use of other batteries may damage the instrument or cause the Battery Pack to leak
liquid, overheat, give o smoke, rupture, or ignite, resulting in serious bodily injury.
Hioki is not liable for any equipment damage or accident resulting from use of a
battery pack other than the Z1007.
If you get electrolyte that has leaked from the Battery Pack in an eye,
immediately wash the eye thoroughly with tap water or other clean
water without rubbing and seek immediate medical attention.
Failure to treat the eye may result in injury to the eye.
WARNING
If the Battery Pack malfunctions during charging, disconnect the AC
Adapter from the instrument or measurement module to stop charging.
If the Battery Pack fails to charge fully in the designated charge time,
stop charging.
If the Battery Pack malfunctions during use, stop using it immediately.
Failure to do so may cause the Battery Pack to leak liquid, overheat, give o smoke,
rupture, or ignite, resulting in bodily injury.
If the Battery Pack is leaking electrolyte or giving o an unusual odor,
move it away from re immediately.
Failure to do so may cause the leaked electrolyte to ignite, causing bodily injury.
CAUTION
Do not use the Battery Pack in locations where it would be exposed to direct,
strong sunlight or where it would become hot, for example inside a vehicle on a
hot day.
Do not leave the Battery Pack in hot locations.
When using the Battery Pack for the rst time after purchase, avoid use if you
notice any rust, unusual odor, overheat, or other anomaly.
Doing so may cause the Battery Pack to leak liquid, overheat, give o smoke, rupture,
or ignite, resulting in bodily injury. It may also lower the Battery Pack’s performance
and reduce its service life.
If you get electrolyte leaked from the Battery Pack on your skin or clothing,
immediately rinse with tap water or other clean water.
Electrolyte may irritate the skin.
NOTICE
Be sure to use the included screws to close the cover.
Use of screws that are longer than the included screws could damage the instrument.
Making Connections (Preparing for Measurement)
To Next Page
Loading...
Need help?
General
