76
Basic Operation
3.1 Basic Operation
You can congure settings by operating the instrument’s keys.
You can switch between main and sub tabs on the settings screens.
See “1.1 Performing Basic Operations” in the Instruction Manual.
In this manual, the selected active item is said to have “focus.”
The background of the selected item will turn yellow.
Switching among the main tabs
Press the SET key to display the settings screen.
You can switch the seven screens with main tabs listed at the top of the screen.
[Unit], [Measure], [Channel], [Trigger], [Alarm], [Calculation], and [System].
• You can switch among the main tabs using the Left Arrow and Right Arrow keys.
• You can move the focus among sub tabs by pressing the ENTER key.
• You can return the focus to the main tab by pressing the ESC key.
• You can also switch among the main tabs using the SET key.
Return to [Unit].
Unit Measure Channel Trigger Alarm Calculation System
Switching among the sub tabs
After selecting a main tab, you can switch the screen’s contents further with sub tabs shown on the
left side of the screen.
• Select the sub tab whose settings you wish to congure with the Up Arrow and Down Arrow
keys.
• You can move the focus to the settings area by pressing the ENTER key.
• You can return the focus to the sub tab by pressing the ESC key.
Display
Manual save
Auto save
Record
Settings
Main tabs
Sub tabs
Meas_1.png
Focus
For example, once you have selected the [Measure] main tab, you can switch
the screen’s contents among the following ve sub tabs:
[Record], [Auto save], [Manual save], [Display], and [Settings].
Return to [Record].
To Next Page
Loading...
Need help?
General
