DIGI*TRAC Annunciator User’s Guide
8
Assigning Annunciator Privileges
The process of enabling the DTA for the controller depends on the
host PC software used. There are three methods for assigning
Annunciator privileges to a user:
● Keypad assignment (programming)
● SAM assignment
● Velocity assignment
Each of these methods is discussed in this section.
Keypad Assignment
To assign Annunciator privileges from a ScramblePad:
1. From an attached ScramblePad, enter program mode.
2. Use the following command and syntax to assign Annunciator
privileges to a user:
44*1*User Number*Code
where User Number is the number assigned to this user and the
Code is the PIN number assigned to this user at this door to
activate the DTA.
SAM Assignment
To assign Annunciator privileges using SAM:
1. Access the Add/Edit User Group worksheet by selecting Add
Group in the Groups menu, or press F3 Add.
2. Either define a new group or select an existing user group.
3. In the “Function” field, select the Alarm Control button then the
Alarm Cancel function.
To Next Page
Loading...