HIRSCH DIGI TRAC User Manual

DIGI*TRAC Annunciator User’s Guide
14
Operating the Annunciator
The following procedure shows you how to use the Annunciator.
1. Go to the keypad (either ScramblePad or ScrambleProx) or card
reader connected to the DTA. This normally will be the keypad or
reader mounted closest to the DTA.
Whenever the DTA is not activated, it displays the time and day
like this example:
Figure 12: Inactivated DTA Screen
2. Perform one of these procedures:
• At the keypad, enter your special DTA-activation code. This is
often a code extension (SAM) or function group (Velocity).
• At a reader, swipe your special DTA-activating card.
 Your regular access code cannot activate the DTA. The
code must be used with an extension digit or function
group digit. The system administrator must issue you
this special code extension to activate the DTA.
The DTA is activated. The DTA’s screen displays the initial screen
like Figure 13.
Figure 13: Annunciator Main Menu
END
ALM
LOG
INP
STAT
RELAY
STAT

HIRSCH DIGI TRAC Specifications

General

Brand	HIRSCH
Model	DIGI TRAC
Category	Controller
Language	English