HIRSCH DIGI TRAC - User Manual

DIGI*TRAC
Annunciator Guide
DTA001-0602

Summary

Getting Help

Contact Hirsch Technical Support

Direct contact information and methods for reaching Hirsch Technical Support for troubleshooting issues.

Introduction

Supported Status Requests

Details the types of status information the DTA can display, such as alarm logs and input/relay status.

Installing the Annunciator

Annunciator Activation Requirement

Highlights the need for a ScramblePad code or card to activate the DTA display.

Required Components for Installation

Lists the essential components needed for a typical DTA installation, including the controller and reader/keypad.

Connecting a ScramblePad

Detailed steps for connecting the DTA to a ScramblePad, including wiring to the MATCH2 board for activation.

Connecting a Reader

Instructions for connecting a reader to the DTA, covering wiring, port configuration, and power sourcing.

Connecting a ScrambleProx

Steps for connecting a ScrambleProx to the DTA, including cable routing and operator access methods.

Assigning Annunciator Privileges

Keypad Assignment Method

Assigns Annunciator privileges to a user via a ScramblePad using a specific command and syntax.

SAM Assignment Method

SAM Programming Details

Velocity Assignment Method

Function Group Assignment in Velocity

Velocity Function Group Configuration

Single Credential Assignment in Velocity

Velocity Credential Configuration

Operating the Annunciator

DTA Activation Procedure

Details on activating the DTA using a special code or card at the connected keypad or reader.

Annunciator Main Menu Navigation

Alarm Log Display

Input Status Display

Relay Status Display

Alarm Log Management

HIRSCH DIGI TRAC Specifications