HIRSCH DIGI TRAC User Manual

DIGI*TRAC Annunciator User’s Guide
2
Both a picture and an illustration of this front panel is shown in
Figure 2:
Figure 2: DIGI*TRAC Annunciator – Front View
These keys are used for status requests only and cannot issue
commands of any sort.
Status requests supported are:
● Alarm Log Display from the Controller's Alarm Buffer (holds last
256 alarms)
● Current Relay Status (to determine whether a door is locked)
● Current Input Status (to determine where a door is closed or a
device is secured)
This unit requires a CCM v.7.0.21 or later but does not require any
host software for setup or operation. It is ideal for lobbies and other
passages outside of the secured area where an individual can confirm
that the protected area is secure (such as locked and ready to leave).
4-line LCD screen
4-button keyboard

HIRSCH DIGI TRAC Specifications

General

Brand	HIRSCH
Model	DIGI TRAC
Category	Controller
Language	English