Hirschmann BAT867-R - Connecting the Power Supply through a Terminal Block; Connecting Data Cables; 10;100;1000 Mbit;S Twisted Pair Port

26
Installation BAT867-R
Release 06 08/2018
By connecting the supply voltage via the terminal block, you start the
operation of the device.
2.5.1 Connecting the power supply through a terminal
block
Relevant for North America:
The torque for tightening the supply voltage terminal block on the device is
4.5 lb-in (0.51 Nm).
 Mount the terminal block on the device using screws.
 Enable the supply voltage.
2.6 Connecting data cables
2.6.1 10/100/1000 Mbit/s twisted pair port
Further information:
See “10/100/1000 Mbit/s twisted pair port” on page 19.
 Connect the data cables according to your requirements.