Installation BAT867-R
Release
06
08/2018
31
5 Configuring the transmit power
Note: The operator of a WLAN radio installation must adhere to the
applicable transmission threshold values.
Use the graphical user interface or the LANconfig software. You can
download the LANconfig software as an ISO image from the Hirschmann
product pages (www.hirschmann.com).
In the graphical user interface, proceed as follows:
In the menu tree, open the Configuration > Wireless LAN > General
dialog.
In the “General” tab, specify in the “General” frame the country in which
you install the device, and click the “Send” button.
Note: For devices that are operated in the European Union perform
thework steps described in chapter “Obtain compliance for operation in
the European Union” on page 28.
In the menu tree, open the Configuration > Wireless LAN > General >
Physical WLAN settings - Radio dialog.
In the “General” tab, click in the “Interface” column the physical WLAN
interface to which you connect the antenna.
To Next Page
Loading...
