Installation BAT867-R
Release
06
08/2018
29
Note: To check the country setting and correct it, type no. Then check
the country setting with the following command: ls Setup/WLAN/
Country.
To obtain RED compliance, type yes. This makes the country setting
unchangeable. Subsequently, the device restarts.
Graphical user interface
Open the Configuration > Wireless LAN > General dialog and select
the desired country setting.
Note: The country setting “Europe” is valid for all European countries.
Specific country settings such as “France” or “Germany” include
additional country specific channels in comparison to the “Europe”
country setting.
The device ignores specific country settings and uses the country
setting “Europe” until the RED compliance has been obtained.
To confirm your choice, click the “Send” button.
Open the Extras > RED compliance dialog.
Note: To check the country setting and correct it, open the
Configuration > Wireless LAN > General dialog.
To obtain RED compliance, click the “Confirm RED compliance”
button. This makes the country setting unchangeable. Subsequently,
the device restarts.
LANconfig
In the LANconfig device overview, highlight the row containing the
desired device.
In the menu bar, select Device > Configure.
Open the Configuration > Wireless LAN > General dialog and select
the desired country setting.
Note: The country setting “Europe” is valid for all European countries.
Specific country settings such as “France” or “Germany” include
additional country specific channels in comparison to the “Europe”
country setting.
The device ignores specific country settings and uses the country
setting “Europe” until the RED compliance has been obtained.
To Next Page
Loading...
