Hirschmann iFLEX5 - Page 20

Operator's Manual iFLEX5
© Hirschmann Rev. E 11/12/08 190147_E
14
• (if selected on rubber mode only)
static
pick & carry
• Setting the reeving (parts of line)
increase reeving
decrease reeving
confirm reeving
• Confirmation of the programming procedure
At the end of the procedure all selections are shown once again in symbolic forms. If selections have
been made, the corresponding symbols are filled black.
quick setting the reeving
(⇒ chapter 4.3)
quick hoist line selection
(⇒ chapter 4.2)
cancel procedure
confirm inputs
counterweight
configuration
(optional)
hoist
selection
boom
configuration
outrigger
configuration
reeving
(parts of line)